Table fittings Land Rover SIIa

[Yellow Peril]

Good morning to you all on the forum,
Yesterday my land rover was reunited with its origonal wardrobe and table. I managed to find the first owner, (i am the second) and he still had them. When I look on the back door, the black trim is still there and a couple of pop studs. But the brackets for mounting the table to the back door are gone!!! 🙁
Does any one have any drawings or a couple of photos of these. As I would like to remanufacure some.
I have just finished fitting a new roof vent and the brackets that attach to the vent where missing. I knew the hole centres and so could measure them from the computer screen!!! As for the table attachments I canno t find any clear pictures.

Thank you for reading my post.
😉
Andy

[Jabbawocky]

HI Andy

I think all the fittings are still there on Barney’s back door. You are welcome to come round and photograph/measure them for yourself.

Just wish I had a table to go with them!!!!

Mick 07815 882365

[Yellow Peril]

Thanks Mick.
P.M sent.

Andy

[Bea]

@Jabbawocky wrote:

HI Andy

I think all the fittings are still there on Barney’s back door. You are welcome to come round and photograph/measure them for yourself.

Just wish I had a table to go with them!!!!

Hi Andy,
I can photograph it all for you.
(and I have got the table to go with them and it came from Mick!!!!!)
Phil

[Yellow Peril]

Thanks Bea,
I have been to Mick’s and had a good luck at the fittings on his back door. One of the three was missing. So any photos or measurements would be most helpfull. If you put them on the forum others will be able to see them too, for future referance.

Thanks Again. Andy

P.s more questions coming….. curtain layout, colour of cabinets….etc 😆

[Bea]

Right ho sorry it has taken so long but as promised a few photos of the table mountings on Bea:

[/img]

One small L shaped bracket to hold the side edge of the table to stop it fouling on the kitchen unit is missing, its position is marked by the screw holes just to the left of the lock cover trim.
Hope thats some help.
Phil

[Author]

Posts