Re: Re: Where does this trim go please?
Here are the photos I took for Alex on New Years’. A bit dark. I’m afraid it was foggy and cold.
I have almost none of the original PVC edging which is on most of Alex’ pieces. Does anyone know where to get some?
Also, the board I used as a replacement is ca. 0.5mm too thick, so the originals weren’t the best templates. There is surprisingly little tolerance. I have had to taper the edges to get some of them to fit. Of course I will save the originals in case I have to re-do any of this.
The way I fit the rear retractable shoulder belts, I can’t use the standard panels on the side of the tub, behind the rear seats. I will modify them. The metal cover over the tub galvanizing is also in a bad spot as far as being sharp and rubbing on the seatbelt, so again I will need to modify it before installing them (I will use edging).[attachment=0:3azodsp5]rightsidetrim01.jpg[/attachment:3azodsp5][attachment=1:3azodsp5]headlinerleft01.jpg[/attachment:3azodsp5][attachment=2:3azodsp5]leftsidetrim02.jpg[/attachment:3azodsp5][attachment=3:3azodsp5]leftsidetrim01.jpg[/attachment:3azodsp5][attachment=4:3azodsp5]flatpanelmount01.jpg[/attachment:3azodsp5]
