Re: Re: Trim materials
Hi
I used the same material as was used originally the thin Millboard stuff you can buy it in B&Q, and covered it in white headlinning from Woolies.
The large front panel above the seats i cut from a large sheet and wet the ends one side at a time and tucked it between the wall and a radiator (i have round wide cast iron radiators very handy for this) and placed various books magazines to create the curve i did this over a few days,the long panels above the rear passenger doors was done the same way although this was more difficult due to the shorter width had to score the back of the boards horizontally to allow the panel to bend.
If i was doing it again i would be inclined to use 2mm aluminium and get a sheet metal shop to roll it into the correct curve, when trimmed you would be none the wiser.
Regards
Malcolm
